Description Summary Job Description: Responsible for final finishes running machine. This involves tasks related to set-up, machine operation, and disposing of chips as required. Job Functions and Functional Job Task Elements Task 1: Operate Machine • Receive metal rolls from machine area-a jib crane can be used to lift heavier items. • Check prints for specific job. • Parts placed and measurements taken and tool marked prior to running job. • Need a forward reach of 32”. • Gripping of parts and tools. • May need to utilize drivers to operate the machine-can weigh up to 90#. • Change out bearings as needed. • Must monitor machine operation carefully due to close tolerance of machine operation-final finishes on neck and barrel. • Trunk flexion and twisting. • May utilize stool for sitting if needed to observe and monitor machine while running. • Walk back and forth to monitor machine. • Visual inspection of part. Task 2: Maintain Machine and Surrounding Area • The chips on this machine need be shoveled into pit. • Oil/water mix with -soda ash. • Check machine for maintenance: check fluids, etc. • Complete time sheet per job: materials and time noted. • Keep area clean, sweep, pick up debris, etc. Note: This job description is not intended to be all-inclusive. The employee may be required to perform other duties as assigned. If you meet the requirements above and are interested in joining our team as a Laborer, please apply with your updated resume. We look forward to reviewing your application! Requirements Shift: 8 hours regular shifts and 12 hours over-time shifts. Breaks: 30 minute lunch. Flooring: Cement, wooden platforms, grates, rubber mats. Environment: Machine shop environment. Need to be careful with other employees while moving overhead cranes in the vicinity. Safety Equipment: Hard hat, gloves, safety glasses, and steel-toe shoes. Strength Range: Medium-Heavy strength range. Tools and Equipment: Roll grinder, various hand tools, chip pushers, cranes, shovels, brooms, etc. This list is not all inclusive.