Overview Perform machine tending operations and processes; count, stage and record finished parts. Remove burrs and sharp edges from manufactured parts using hand grinders, dynafiles, Burr Master and Tumbler. Responsibilities • Pull finished laser cut parts from the load tables and stack on carts. • Operate hand/air tools and electric grinders. • Verify part counts to the number of parts nested by the laser programmer. • Locate parts that have fallen to the ground through the table grates. • Accurately complete the Work Order paperwork. • Attach applicable part tags. • Move laser cut parts to the correct locations based on the next operation as dictated on the Job Travelers. • Empty the slag pans daily. • Clean the floor under the load table daily at specified time(s). • Complete daily 5S requirements. • Clean the lasers weekly. • Assist in other duties as requested by trainer, manager or supervisor. Qualifications Education and Experience: • High school or general education degree (GED). • Machine shop experience is a plus. Skills and Abilities: • Read and interpret documents such as safety rules, operating and maintenance instructions, and procedure manuals. • Complete standardized written documentation and correspondence. • Professionally communicate in one-on-one and small group situations. • Ability to perform basic electronic tasks using computer software and Microsoft Office. Working Conditions/Physical Demands: • Environment is a modern production facility with heat and air conditioning • While performing the duties of this job, the employee is generally required to stand; use hands and fingers to manipulate raw materials, finished parts and cutting tools • Ability to twist at the waist 180 degrees (side to side) repetitively • Ability to squat/bend and lift up to 15 pounds to place parts on machine at chest level repetitively • Ability to lift 16 to 50 pounds occasionally • Ability to squat and lift up to 75 pound fixtures to place on machine at chest level occasionally, with assistance • Ability to reach over head with one arm to adjust setup dial regularly