$25 to $30 per hour | First shift, 7:00 AM to 3:30 PM, Monday to Friday | Plymouth, MN Ready to be the hands everyone else measures up to? Source Engineering & Manufacturing is looking for a Senior Cable and Wire Harness Assembler to join our Plymouth, MN manufacturing site. This is a senior individual-contributor seat: you'll take on our most complex builds, run first articles, and set the workmanship standard newer assemblers learn by watching you work. Your Role Will Include: • Build our most complex cable and wire harness assemblies from drawings, schematics, and work instructions with minimal supervision. • Perform precision wire cutting, stripping, crimping, soldering, potting, labeling, and bundling to IPC/WHMA-A-620 standards. • Run and document first-article builds, helping dial in fixturing and tooling before a job moves to volume. • Read complex engineering drawings and flag errors or ambiguities back to engineering. • Inspect your own and others' work for quality and compliance. Qualifications: • 3-5 years of hands-on cable and wire harness assembly experience. • Demonstrated mastery of crimping, soldering, and connector termination across multiple connector families. • Ability to work independently from complex engineering drawings, wire lists, and schematics. • Proven first-time-right workmanship and low defect rates. • Strong attention to detail and disciplined, repeatable technique. • Experience building complete cable assemblies end-to-end, not single-station/high-volume work. • IPC/WHMA-A-620 workmanship standards experience, even without formal certification. Preferred • Current IPC/WHMA-A-620 certification (CIS); training and certification provided if not already certified. • IPC/WHMA-A-620 CIT (Certified IPC Trainer). • J-STD-001 soldering certification. • Control panel build experience. Salary and Benefits: • $25–$30 per hour, based on experience and certification level. • 401(k), health and dental insurance, and performance bonuses. Location & Shift Times: • Plymouth, MN (on-site). • First shift, 7:00 AM–3:30 PM, Monday–Friday; FT. Physical Demands: • Fine motor control, close vision, and sustained focus at a bench. • Frequent repetitive hand/wrist movement; extended periods seated or standing. • Occasional lifting and moving of parts up to 35 lbs.