Job Details: Job Location: DNY - Mamaroneck, NY, Position Type: Full Time, Salary Range: $26.00 - $38.00Hourly, Derecktor is looking for full time Outside Machinist to install, inspect, repair, and replace mechanical, propulsion, steering, and hydraulic systems on vessels. You will report to our Mechanic Foreman on assigned projects. Essential Duties and Responsibilities: These shall include, but not necessarily be limited to the following: Comprehend blueprints, sketches, and templates. Ability to identify interferences or discrepancies in plans and drawings. Understand shipyard operation and safety protocol. Perform routine inspections, maintenance and repair of marine equipment and vessels. Diagnose mechanical system problems and determine necessary repairs. Inspect propulsion systems and determine proper repair methods. Perform rigging and removal of shafts and rudders. Remove / install propellers; dye check and dial indicate shaft tapers. Disconnect / reconnect couplings from shaft and output flange of transmission. Perform engine alignments. Replace cutlass bearings. Removal and replacing of seacocks, ball valves, and hoses. Inspect, remove, and replace seals. Test and diagnose steering systems and hydraulics. Inspect struts and rudders and perform necessary repairs. Removal and replacement of generators and rigging. Perform work on steering systems, hydraulic systems, cylinders, and rudder bearings. Follow all safety procedures including utilization of proper personal protective equipment (PPE); maintain a clean and safe work area Qualifications: Knowledge, Skills, and Abilities: Strong mechanical and mathematical aptitude. Adapt to changes quickly and seamlessly. Ability to work independently and as part of a team. Ability to work efficiently in all types of weather conditions. Knowledge of blueprints and marine mechanical systems. Must be able to travel Required Qualifications: Minimum 2 years of marine mechanical experience. Knowledge of marine mechanical equipment and systems. Knowledge of all running gear and drive lines. Knowledge of cutlass bearings, shaft seals and the removal of. Understanding of blueprints and drawings of systems and layouts. Able to maneuver and fit in confined spaces while working with heavy equipment.