In Depth knowledge of DFMEA, PFMEA, CP and PFD Method support (Sys. - FMEA, D-FMEA, HW-FMEA, P-FMEA IQ-RM / IQS Moderation.) Carry out the FMEA based risk analysis and ensure the release of FMEA by closing all the risk points. Preparing and Monitoring of Control Plan Prototype, pre-launch and production Hand on experience with Measuring instruments, CMM, VMM, rapid I, Vernier caliper etc. Child part Inspection and ISIR release for new development projects. Inprocess inspection, setup verification and support for process maturity during development. Attend the molding trial in-house and at supplier end to ensure the required improvements. Support for review of drawings for specifications special characteristics Preparation of PPAP documents and customer approval. In house process Audits to make sure, defined spec. has been followed during assy. Must have hands on Experience on Problem Solving Technique – G8D, CAPA QC Tools Must have experience of PPAP and APQP Documentation. Conducts SPC and MSA study Hands-on experience with Gauges concept review and finalization as per customer requirements. Verification of assy. fixtures, receiving gauges final assy. gauges. Monitor the quality objectives achievement through a risk assessment follow up based on FMEA, key characteristics, capabilities, tolerance stack up, PPM etc. Attend project review meetings internal and along with customer. Handling customer PPAP, internal and compliance audits. Must have the Knowledge of IATF and Auditing Skill Experience in handling the Quality work products in line to IATF16949 and ISO26262 requirements.