The Projection Welder will serve our Water Heating Division, located in Montgomery, AL. • Must be able to operate resistance-welding equipment to fabricate parts according to print specifications. • Must be able to set-up welding machine. • Must be able to run an automated piece of equipment independently. • Must be able to change out dies in an automated piece of equipment. • Must be able to troubleshoot sequencing error on an automated piece of equipment. • Must be able to perform routine maintenance on machine. • Must be able to fill out daily production report detailing what was produced for that day. • Must be able to identify and label parts produced. • Must be able to interpret measurement devices such as a tape measure. • Must be able to perform quality checks which includes but not limited to material destructive testing. • Must be to perform our duties in the work center as directed by supervision. • Maintain good housekeeping in work area. • Observe all departmental safety requirements. • Maintain quality standards according to specifications. • Inspect units or parts for defects and workmanship. • Work from written or verbal orders. • Practice and support Rheem values with internal as well as external customers. • May be exposed to high noise levels, heat, dust and airborne particles. • Performs other duties as assigned. • High School Diploma/GED. • Must be able to add, subtract, divide and multiply whole numbers. • The following skills will be tested: Lift truck. (3rd shift only). • Continuous lifting of 25-60 lbs. • Occasional lifting of 60+ lbs. • Must be able to stand, walk and/or lift repetitively during shift. • Must be able to frequently lift in unsupported positions as well as bend, twist/turn, reach, push/pull. • Vision acceptable to determine proper welds.