Description • Part-time- 4 pm- 8 pm Monday-Thursday • Pay $17.25/ hour • Entry Level assembly and machine operating. • Job Specifics: • You will work with sensor insertion, bonding brushes, silver painting and copper coating. • Read shop orders and inspect parts from various pieces of equipment to ensure compliance with established drawings and specifications. • Work on kick press and/or punch press to install terminals on carbon brush. • Use concave machine to place angle on carbon brush. • Place copper wire through hole in carbon brush and secure with rivet. • Seal wires and glue pads to carbon brush and place in oven. • Take out of oven and clean off excess glue. • Cut wire by specifications on shop order. • Place copper wires through hole and secure with rivet. • Solder brush per order specifications. • Place sleeve (silicone cover) over wires. • Clean/tidy your work area • Be able to be cross trained in the department to perform different duties. • Work with production supervisor and other department personnel in a cooperative and collaborative manner to expedite orders within the department so as to meet and exceed customer expectations in a cost-effective manner. Job Requirements: • Ability to successfully read and utilize inspection and measuring instruments (calipers, micrometers, protractors and ruler required). • Requires being able to lift and/or move up to 25 pounds. • Need to read and speak English to review Shop Order requirements required. • High school diploma or equivalent preferred. Job Type: Part-time Pay: $17.25 per hour